Loading... Please wait...
Popular Brands
Our Newsletter
New Products
- Home
- Spectrum Analyzer
- Agilent E4440A Spectrum Analyzer 26GHz
Agilent E4440A Spectrum Analyzer 26GHz
Product Description
This unit is in great condition.
It works well and has options 123/124/215/HN9/HB2 , the analyzer was last calibrated in June 2013.
Firmware rev is A.11.01
This unit is in great condition
It has options 123/124/215/HN9/HB2 ,
Performance
+/-0.19 dB absolute amplitude accuracy
-155 dBm (-169 dBm w/preamp) displayed average noise level (DANL)
-118 dBc/Hz phase noise at 10 kHz offset
81 dB W-CDMA ACLR dynamic range
Analysis bandwidth
10 MHz analysis bandwidth (Option B7J for the Basic mode)
Optional 40 or 80 MHz analysis bandwidth to capture and measure complex signals.
-78 dB (nominal) third order intermodulation for 40 or 80 MHz analysis bandwidth
Up to 300 MHz analysis bandwidth for calibrated VSA measurements
Flexibility
Flexible platform with 16 optional, easy-to-use built-in measurement personalities and hardware options
Option Information
123 -Switchable MW preselector bypass
As with most spectrum analyzers, a microwave preselector is employed above 3 GHz. An RF preselector can adversely affect the frequency response and phase linearity in the preselector pass band. To avoid this
problem, Keysight offers a switched microwave preselector bypass Option 123. For better amplitude and phase measurements above 3 GHz, Option 123 is highly recommended. By avoiding the preselector, measurements can be made with far less amplitude variability, thus greatly
increasing repeatability. Passband ripple in amplitude and phase is reduced when not using the preselector.
124 - Y-Axis Video Output
Log and linear display scales. Output scaling: 0 to 1.0 V open circuit
Gain accuracy: ±1% of output voltage. Operates in spectrum analyzer mode only
215 External Source Control Measurement Personality, Fixed Perpetual License
Supports MXG control. Now you can take advantage of MXG, such as measurement speed and cost, when making your scalar network analysis
A variety of sweep modes including standard sweep, harmonic sweep, offset sweep (normal/reverse), and power sweep offer the optimal tools for characterizing different types of components.
Wide dynamic range (up to 108.9 dB on Option 215’s defaulted setting) allows accurate tests for components with the presence of high and low power levels at the same time. Narrow RBW (up to 1 Hz on manual setting) eliminates the distortions caused by harmonics from swept signal
sources when measuring passive devices. One-button normalization and Open/Short calibration further improve the measurement accuracy by removing frequency response errors of the test system
Capability to control Keysight MXG, ESG, or PSG signal generators allows you to do network analysis while maintaining all the benefits of a stand-alone signal generator
HN9 - Wideband IF Out
Performance
+/-0.19 dB absolute amplitude accuracy
-155 dBm (-169 dBm w/preamp) displayed average noise level (DANL)
-118 dBc/Hz phase noise at 10 kHz offset
81 dB W-CDMA ACLR dynamic range
Analysis bandwidth
10 MHz analysis bandwidth (Option B7J for the Basic mode)
Optional 40 or 80 MHz analysis bandwidth to capture and measure complex signals.
-78 dB (nominal) third order intermodulation for 40 or 80 MHz analysis bandwidth
Up to 300 MHz analysis bandwidth for calibrated VSA measurements
Flexibility
Flexible platform with 16 optional, easy-to-use built-in measurement personalities and hardware options
WRITE A REVIEW